AnyVases started with a simple question: what can a vase look like when it doesn't have to come out of a mould? We design sculptural vases and 3D-print them in our studio in Malta, one at a time, from 100% recycled PETG.
Made in Malta
Designed and printed in our own studio.
100% recycled PETG
The colour runs through the material.
Holds water
Fresh flowers welcome.
Checked by hand
Every vase, before it is packed.
Why 3D printing
Shapes a mould can't make
3D printing lets us build forms that would be hard to make any other way: deep spirals, rippled surfaces, fine ribs and slender flared necks. Each design is drawn, test-printed and refined until it looks right from every angle.
How it's made
Printed in Malta, layer by layer
Every vase is printed in our studio in Malta from 100% recycled PETG, one fine layer at a time. The spirals and flutes are part of the form itself, not painted on, and the colour runs right through the material, so there is no paint to chip.
When a print is finished we check it by hand, then pack it to travel safely across Europe.
One at a time
No two quite the same
Because each vase is printed individually, you may see fine layer lines and slight colour differences between batches. We think that is part of the charm: a quiet trace of how your vase was made.
AnyVases is a brand of MaltaCareersHub Ltd, based in Mosta, Malta. We ship to Malta and across the EU.
